Dexron 2 transmission fluid equivalent


Dexron II is an approved alternative to Type CJ. Mercon—introduced in 1987 and similar to Dexron II. Ford ceased licensing Mercon in 2007 and now recommends Mercon V for all transmissions that previously used Mercon. Mercon is a suitable replacement for Type H and Type CJ fluid, but not for Type F.


Is Honda at fluid really Dexron?

The Honda Odyssey should get a transmission fluid change every 90,000 miles. It uses Dexron VI Transmission Fluid and has a capacity of 3.3 quarts. When should I change my transmission fluid Honda Odyssey 2018? Most new vehicles are equipped with an automatic transmission. As a result, there’s not really much maintenance to perform.

What is the difference between Dexron III and Mercon V?

Dexron III and Mercon V are similar types of automatic transmission fluid, with the main difference being that Dexron is the formula developed by General Motors, while Mercon was created by Ford. The specifications of the two formulas are so similar that the two are often considered interchangeable, even if the car manufacturer recommends only using its specific formula.

Can you use Dexron II instead of dexroniii?

stated to use Dexron II. If you look on the back of the Dexron III quart, since 1967. I would say it is compatible. I do not even think you can buy Dexron II anymore at part store. >I have an ’87 Trans Am with 4 speed auto trans (700 R4).

What is Dexron II?

General Motors referred to its ATF as Dexron II and Ford’s specified fluid was labeled Mercon. Ford first produced its own ATF in 1967 and referred to as Type F. The name comes from Ford’s specification number for the fluid, ESW M2C33-F. This fluid was used in all Ford transmissions until 1977 and most Ford transmissions until 1980.


What replaces DEXRON II transmission fluid?

Dexron VIDexron VI replaced Dexron II and III, and can be used in General Motors domestically built or import transmissions that specified Dexron II or Dexron III. Dexron VI is a low viscosity transmission fluid and should also be used with the full synthetic low viscosity transmission fluid.

Can I use DEXRON II instead of vi?

DEXRON-VI is also compatible with any former version of DEXRON for use in automatic transmissions. TIP: Simply topping off the fluid is adequate, but a full drain and replacement is preferred, to obtain the full benefit.

Is DEXRON 2 and 3 the same?

Dexron-III(F) has the same low-temperature fluidity as Dexron-II(E), for better transmission performance in cold weather.

What is dexron 2 transmission fluid?

ATF Dexron II-D is a premium, automatic transmission oil based on solvent-refined base oils. It is supplemented with additives to achieve the following properties: A very high and stable viscosity index. A very low pour point.

Is it OK to mix transmission fluids?

The most common situation where the wrong transmission fluid is used is in the case of using automatic transmission fluid in place of variable transmission fluid and vice versa. Adding ATF to a to a CVT will eventually result in the death of your transmission.

What happens if I use the wrong transmission fluid?

Using the wrong fluid can cause poor lubrication, overheating, and possibly transmission failure. A mechanic might not be able to reverse the damage, even by flushing the transmission. Mistakenly adding motor oil or brake fluid can also destroy your transmission.

Can I use DEXRON 3 instead 2?

Dexron III supercedes DII and can be used in lieu of DII.

Can I use DEXRON 2 instead 4?

ATF IV and Dexron II are different enough I’d suggest against using it, however all Dexron fluids are backwards compatible, so you could use Dexron III or Dexron VI. If you can get Dexron III you can mix it with the exiting Dexron II in your power steering reservoir without issue.

Are all DEXRON fluids compatible?

Yes, DEXRON-VI fluid can be used on any vehicle type that calls for DEXRON transmission fluid.

Is DEXRON 2 fully synthetic?

Quality: Fully Synthetic(3)

What viscosity is DEXRON 2?

Viscosity. Kinematic @ 40°C = 42.5 cSt.

What is the best transmission fluid for a 4L60E?

Let’s look at the GM 4L60E automatic in a 2000 Camaro or Corvette. Dexron VI is often claimed as the proper fill yet Dexron VI didn’t appear until 2005, which means this transmission was originally a factory fill with Dexron III. This isn’t a huge problem since Dexron VI will certainly work.

What kind of transmission fluid goes in a 4L60E?


Can I use DEXRON 4 instead 2?

ATF IV and Dexron II are different enough I’d suggest against using it, however all Dexron fluids are backwards compatible, so you could use Dexron III or Dexron VI. If you can get Dexron III you can mix it with the exiting Dexron II in your power steering reservoir without issue.

What does DEXRON III mean?

ATF Dexron-III is a premium automatic transmission fluid specially formulated to meet the needs of today’s more compact transmissions, running at higher operating temperatures and with electronic control.

Is Dexron III thicker than Dexron-VI?

The old DEXRON-III specification was not required to retain its viscosity like DEXRON-VI fluids. It may start out thicker but DEXRON-VI is guaranteed to retain the viscosity better. That is a key aspect of the upgraded specification along with superior oxidation resistance. DEXRON-VI is a superior specification in every aspect.

Is the Dexron 3 license still valid?

And of course the old Mercon or Dexron III license is no longer current. It is a matter of trust in the manufacturer of the product one uses. There is no doubt about that.

Which is superseded by Dexron 2?

Well . . . Dexron 2 was eventually superseded by Dexron 3

What kind of bottle of lubegard should I use for a Honda automatic transmission?

Dexron III is the latest but, if you use that in a Honda automatic, you need to add a bottle of LubeGard black bottle… Honda auto’s need a really high slip agent in their ATF or the automatic transmission will shift harsh. Adding one bottle of LubeGard black bottle. with add enough of that agent to make it shift normal.

What is the difference between Dexron II and Dexron III?

Follow Us: Dexron is the brand name of transmission fluid manufactured for General Motors vehicles; Dexron-II was released in the 1970s, and Dexron-III was released in the 1990s. Dexron-III is considered to be backward compatible …

Why was Dexron II released?

Subsequent versions of Dexron-II were released to compensate for the issues caused by the use of inferior ingredients in the original Dexron-II, including Dexron-IID and Dexron-IIE.

When did Dexron III come out?

Only one version of Dexron-III was ever marketed after it hit the market in 1993, and it was replaced by Dexron-VI in 2005.

Is Dexron III backward compatible?

Dexron-III is considered to be backward compatible with other versions of Dexron, meaning it can be substituted for Dexron-II and other older versions of the fluid. However neither version of the transmission fluid is currently manufactured or marketed, and the most current version, Dexron-VI, is used in a backward-compatible fashion …


Leave a Reply

Your email address will not be published. Required fields are marked *